• Fusion

Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection

Outline
1

Getting started

Module overview
Course overview
Get the software
Get the Haas tooling
Course resources
2

Create and rough a new setup for OP2

Module overview
Create a new setup for caliper and soft
Adaptive clear remaining stock
Face remaining stock
Practice exercise
Challenge exercise
Module quiz
3

Create toolpaths to machine the caliper OP2

Module overview
Rough the caliper with an adaptive toolpath
Use 2.5 axis toolpaths to finish caliper surfaces
Bore mounting holes
Chamfer edges
Practice exercise
Challenge exercise
Module quiz
4

Simulate toolpaths to validate stock removal

Module overview
Simulate toolpaths
Machine simulation
Create a setup sheet and NC program
Practice exercise
Challenge exercise
Module quiz
5

Machine the brake caliper OP2

Module overview
Set up soft jaws to be machined
Machine soft jaws
Module quiz
6

Final part inspection for the brake caliper

Module overview
Visual part inspection
Manual inspection setup
Manual part inspection
Probe geometry
Practice exercise
Challenge exercise
Module quiz
7

Course challenge exercise

Module overview
Course challenge
8

Final test

Module overview
Start your final test
  • Up next:Create toolpaths to machine the caliper OP2

Module quiz

5 questions

1. Which 2D Adaptive Clearing toolpath option in the Passes tab will universally control how much material will be engaged with the cutting flute of a tool in the radial direction?

Error: Select an answer

2. Which of the following is an important consideration when planning to use a large shell or face mill to remove large amounts of stock from a part held in a soft jaw?

Error: Select an answer

3. Without any additional selections, where will a facing toolpath machine down to?

Error: Select an answer

4. When creating a new Setup, how can In-Process Stock represent the previous setup’s stock removal and be used in the new setup for toolpath calculations and simulation?

Error: Select an answer

5. How is the machining area previewed while setting up a 2D Adaptive Clearing toolpath?

Error: Select an answer

Error: 5/5 questions unanswered
5/5 questions unanswered
  • Up next:Create toolpaths to machine the caliper OP2

Welcome ${RESELLERNAME} Customers

Please opt-in to receive reseller support

I agree that Autodesk may share my name and email address with ${RESELLERNAME} so that ${RESELLERNAME} may provide installation support and send me marketing communications.  I understand that the Reseller will be the party responsible for how this data will be used and managed.

Email is required Entered email is invalid.

No, thanks, I don't want support from ${RESELLERNAME}
${RESELLERNAME}