• Fusion

Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection

Outline
1

Getting started

Module overview
Course overview
Get the software
Get the Haas tooling
Course resources
2

Create and rough a new setup for OP2

Module overview
Create a new setup for caliper and soft
Adaptive clear remaining stock
Face remaining stock
Practice exercise
Challenge exercise
Module quiz
3

Create toolpaths to machine the caliper OP2

Module overview
Rough the caliper with an adaptive toolpath
Use 2.5 axis toolpaths to finish caliper surfaces
Bore mounting holes
Chamfer edges
Practice exercise
Challenge exercise
Module quiz
4

Simulate toolpaths to validate stock removal

Module overview
Simulate toolpaths
Machine simulation
Create a setup sheet and NC program
Practice exercise
Challenge exercise
Module quiz
5

Machine the brake caliper OP2

Module overview
Set up soft jaws to be machined
Machine soft jaws
Module quiz
6

Final part inspection for the brake caliper

Module overview
Visual part inspection
Manual inspection setup
Manual part inspection
Probe geometry
Practice exercise
Challenge exercise
Module quiz
7

Course challenge exercise

Module overview
Course challenge
8

Final test

Module overview
Start your final test
  • Up next:Course challenge exercise

Module quiz

8 questions

1. How should inspection notes be added to a file in Fusion 360?

Error: Select an answer

2. When manual inspections are defined, where can they be found in the Browser of the Manufacture workspace?

Error: Select an answer

3. If a tolerance is not listed next to a dimension in a detailed drawing, where should the tolerance value be obtained from?

Error: Select an answer

4. How can you fix an issue with uneven chamfers along the Y-axis during the visual inspection process?

Error: Select an answer

5. What is the tolerance set for the Piston bore feature being probed in this video?

Error: Select an answer

6. What is the required name for the dimension capturing the distance between the mounting face and where the brake pad will be seated?

Error: Select an answer

7. Which type of probe is selected from the Fusion probes library?

Error: Select an answer

8. What tolerance is set for the center-to-center distance between the two holes in the manual inspection setup?

Error: Select an answer

Error: 8/8 questions unanswered
8/8 questions unanswered
  • Up next:Course challenge exercise

Welcome ${RESELLERNAME} Customers

Please opt-in to receive reseller support

I agree that Autodesk may share my name and email address with ${RESELLERNAME} so that ${RESELLERNAME} may provide installation support and send me marketing communications.  I understand that the Reseller will be the party responsible for how this data will be used and managed.

Email is required Entered email is invalid.

No, thanks, I don't want support from ${RESELLERNAME}
${RESELLERNAME}