Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection - Challenge exercise | Autodesk

Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection

Outline

1

Getting started

Module overview

Course overview

Get the software

Get the Haas tooling

Course resources

2

Create and rough a new setup for OP2

Module overview

Create a new setup for caliper and soft

Adaptive clear remaining stock

Face remaining stock

Practice exercise

Challenge exercise

3

Create toolpaths to machine the caliper OP2

Module overview

Rough the caliper with an adaptive toolpath

Use 2.5 axis toolpaths to finish caliper surfaces

Bore mounting holes

Practice exercise

Challenge exercise

4

Simulate toolpaths to validate stock removal

Module overview

Simulate toolpaths

Machine simulation

Create a setup sheet and NC program

Practice exercise

Challenge exercise

5

Machine the brake caliper OP2

Module overview

Set up soft jaws to be machined

Machine soft jaws

6

Final part inspection for the brake caliper

Module overview

Visual part inspection

Manual inspection setup

Manual part inspection

Practice exercise

Challenge exercise

7

Course challenge exercise

Module overview

Course challenge

8

Final test

Module overview

Start your final test

Challenge exercise

Set up a machine simulation

The challenge: Simulate toolpaths using machine simulation.
Carry on with any design that you have programmed and set up

After completing this challenge, you'll be able to:

Edit a CAM setup.
Use Machine Simulation to validate stock removal.

Exercise