Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection - Practice exercise | Autodesk

Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection

Outline

1

Getting started

Module overview

Course overview

Get the software

Get the Haas tooling

Course resources

2

Create and rough a new setup for OP2

Module overview

Create a new setup for caliper and soft

Adaptive clear remaining stock

Face remaining stock

Practice exercise

Challenge exercise

3

Create toolpaths to machine the caliper OP2

Module overview

Rough the caliper with an adaptive toolpath

Use 2.5 axis toolpaths to finish caliper surfaces

Bore mounting holes

Practice exercise

Challenge exercise

4

Simulate toolpaths to validate stock removal

Module overview

Simulate toolpaths

Machine simulation

Create a setup sheet and NC program

Practice exercise

Challenge exercise

5

Machine the brake caliper OP2

Module overview

Set up soft jaws to be machined

Machine soft jaws

6

Final part inspection for the brake caliper

Module overview

Visual part inspection

Manual inspection setup

Manual part inspection

Practice exercise

Challenge exercise

7

Course challenge exercise

Module overview

Course challenge

8

Final test

Module overview

Start your final test

Practice exercise

Create an inspection report for a part

In this practice you’ll create a new manual inspection report for a caliper bracket.

Learning objectives:

Review a CAM setup.
Create a new manual inspection.
Enter inspection values.
Generate an inspection report.

Exercise

Video solution

0:00 / 0:00