Course 3 - Haas and Autodesk Fusion - Drafting, Soft Jaw Design, and Programming - Set up and machine soft jaws for OP2 | Autodesk

Course 3 - Haas and Autodesk Fusion - Drafting, Soft Jaw Design, and Programming

Outline

1

Getting started

Module overview

Course overview

Get the software

Get the Haas tooling

Course resources

2

Introduction to CAD drawings

Module overview

Introduction to drawings and drafting

Create a basic print of the piston

Practice exercise

Challenge exercise

3

Create a soft jaw for caliper OP2

Module overview

Import soft jaw blanks and vise model

Create a soft jaw for the caliper front operation 2

Practice exercise

Challenge exercise

4

Create toolpaths to machine soft jaws

Module overview

Set up stock and WCS for soft jaw

Program toolpaths for soft jaw

Create an NC program and setup sheet for soft jaws

Practice exercise

Challenge exercise

5

Set up and machine soft jaws for OP2

Module overview

Set up soft jaws to be machined

Machine Operation 2

6

Course challenge exercise

Module overview

Course challenge

7

Final test

Module overview

Start your final test

Associate | ~1 hr. 35 min.

Set up and machine soft jaws for OP2

Module | Skill builder

In this module, you set up soft jaw blanks on a vise and cut soft jaw geometry to be used for operation 2 of the brake caliper.

After completing this module, you’ll be able to:

Assembly soft jaws on a vise.
Set up the WCS on soft jaws.
Load and verify a CNC program.
Machine and verify soft jaws.